Huck
New member
My '06 T1N wants to start but wont. Vehicle has been used very little since returning from Fla to Mi in last 3 wks. A couple of days ago when I tried to start it it would rumble, like it was trying to start, but starter would disengage and engine would quit. A spritz of starting fluid on air filter caused engine to start and run, about 10 sec.
I am getting a P0100 code on scangage. Did reset - came back. P0100 I believe is Mass Airflow Sensor code, would this cause this condition? Is there a way to test MAS before I spend $200+ for a new one.
I would seem this condition could also indicate fuel gelling. I have added Diesel 911 to fuel tank but it is too cold out to get to the fuel filter. Is there a way to cycle the fuel pump to bring 911 through the system?
Thanks in advance for your thoughts.
Huck
Everything I know about my diesel I have learned from you guys...Thanks!
I am getting a P0100 code on scangage. Did reset - came back. P0100 I believe is Mass Airflow Sensor code, would this cause this condition? Is there a way to test MAS before I spend $200+ for a new one.
I would seem this condition could also indicate fuel gelling. I have added Diesel 911 to fuel tank but it is too cold out to get to the fuel filter. Is there a way to cycle the fuel pump to bring 911 through the system?
Thanks in advance for your thoughts.
Huck
Everything I know about my diesel I have learned from you guys...Thanks!