hilld
Well-known member
Now the second panel, the only difference is the opening for the fan. A few measurements and off to cutting a giant square hole. Mark the hole, drill some corner holes and now the dilemma, track saw or jig saw. Track saw won out, leaves for some straighter cuts.
Finish the corners with a wannabe Japanese pull saw.
Finished panel
Test install in the van and test fit the Maxxfan trim ring. About 2 inches too long, time to trim it. Using a utility knife with a few scribes and it cuts right through it.
All installed
Finish the corners with a wannabe Japanese pull saw.
Finished panel
Test install in the van and test fit the Maxxfan trim ring. About 2 inches too long, time to trim it. Using a utility knife with a few scribes and it cuts right through it.
All installed
Last edited: