Hey guys, I made a 3D printed replacement clip for the window regulator on the T1N vans since they are known for breaking.
I'd like to give a few away for testing and get some feedback on it. You just have to remove the guide rail from the bottom of the window glass, Clean and lubricate it, snap the new clip into place and slide it into the guide rail. Shouldn't take more than 5-10 minutes.
If you would like to try it out just PM me
I'd like to give a few away for testing and get some feedback on it. You just have to remove the guide rail from the bottom of the window glass, Clean and lubricate it, snap the new clip into place and slide it into the guide rail. Shouldn't take more than 5-10 minutes.
If you would like to try it out just PM me