om647

2006 Navion on 2005 chassis , 130 k miles and catastrophic eng failure , no codes ,no check engine light , no overheat , 655 miles into trip had a clattering noise that had also an exhaust leak sound to it accompanied by an erratic RPM shift up and down . Pulled to shoulder listened to engine...

OK, I've searched for a half hour and read 20 other threads where I learned good stuff, but I didn't answer my original question. As I understand it, the MAF works with a resistor for heat, semi-conductor, blah blah. I figured I'd simply ohm out the old one and the new one for purposes of...

Lurker for a while and have hit a wall. Quick summary... about 5 months ago my van "roachcoach" started to stutter when going into an incline at highway speeds... about 2 months ago it now stutters and even "bucks" at every gear when i go over 2k rpms. I can get to highway speeds (shifts fine)...

Hello to all and thank you in advance for your input here. I have a 2006 118" WB Cargo van that I use as a service vehicle for my mobile automotive diagnostic and programming business. Long story short, a series of unfortunate events has forced me to overhaul the engine in my van. My current...

i have reman longblock from dodge 2003 sprinter 3500 bought 3-4 years ago, expected the van i had would need it however it still runs great, so i am reducing stuff i need to move i doubt it has warranty even though it has never been out of box 5000.00 in zip code 81023 south of pueblo colorado...

I bought an aftermarket engine block heater from Amazon but I'm having a hard time finding where it goes. The red arrow is blocked by some metal stub (looks like hex, but its fairly rounded form factory) and there are two blue plastic plugs (freeze plugs), but which one do i use? Any help is...

2004 Dodge 2500 Driving home, while coming down from cruising speed to stop, engine quit at low RPM, twice. Pulled codes once I got home (~150mile trip). The pertinent ones (that were not on before) are the following: P0700 transmission Control System (mil Request), my OBD reader showed it as...

So my 2004 Sprinter has a crack on the top of the low pressure fuel pump inside the tank. I already have the pump, gasket and locking ring, but I'm struggling to find the hoses that connect to the top of the pump. Mercedes told me that they've been discontinued, but also that they can't make...

About the van: 2004 2500 OM647 180,000 miles, < 5000 are from me. I've only had it a year. averages about 25mpg, not too smoky (but not crystal clear) This engine starts and runs fine before I started after the head gasket. Van mostly serves light duty applications PO didnt know much about its...

Can you put an om647 alternator on an om611? Can you put a 200ah on the om611? If the alternators are not interchangeable does anyone have information on a bunch of part numbers I can use to find an alternator online for my New Zealand sprinter? I'm guessing I'll buy a 150-amp alternator since...

Hello all, I’m pretty new around here but I was wondering if anyone has some advice on where to purchase a sturdy turbo for my 2006 om647 Sprinter at a decent price? I recently bought the van and it’s turbo went out leading to catastrophic failure. We purchased a new CHRA cartridge from Dynamic...

I'm new to the T1N, I just picked up a solid 2006 (Fed-Ex) for dirt cheap with a bad engine. It was running on 4 cylinders, missing on #1, with a lot of blow by. Im guessing a cracked piston. The rest of the engine looks good, no leaks or anything, clean injectors. I have already pulled the...

Hi guys! I have a 2005 3500 RV conversion with the OM647 engine and about two weeks ago I started to notice a few things with my van that weren’t there before. Van has 191k miles. From a stop it is pretty slow to rev up until turbo pressure builds up and then it takes off. This is especially...

Hi everyone. Currently in the middle of a rebuild of a om647 using .50mm oversized pistons and need a spec on piston clearance to give the machine shop. There is no spec listed in the FSM, and so far no sellers of the oversized pistons have that spec either. Have not contacted the piston...

Hello, I am brand new to the forums. Please forgive me if I'm posting this issue in the wrong section of the forum. I have a 2004 Dodge Sprinter 3500 (named Big Booty Judy). I use the van for my renovation business. It has the OM647 engine with 179,9XX Miles on it. I had black death in...

Hello, while performing my injector replacement. I snapped off the fragile female part of the connector in the back left corner of the valve cover. I am curious if these are standard parts, how to search for them, and if it's easily replaced, or if I should just wrap this bad boy in tape, and...

2006 NAFTA 2500 - Prior FedEx On random intervals between ~100 and ~9,000 miles, my Sprinter will stop "pushing" forward while my foot is on the pedal. The engine continues to run fine. Everything goes back to normal after about a second of the wheels not having power. No restart necessary...