low voltage

  1. papamaze

    Crank, No Start After Alternator Change Out

    About a month ago, my 2010 Sprinter 2500 (165K miles) flashed a battery light on the way home from work. I hopped out and put a voltmeter on the auxiliary battery and read 11.5 volts while it is running. By the time I get home, voltage has dropped to 11 volts. So, I figure the alternator...
  2. M

    2000 W Inverter error code 04 low voltage

    So I have a 2000 W Renogy inverter charger with my electrical. I recently have been using my hot plate to cook and have been getting an error code 04 which indicates low voltage. My hot plate is 750w and I only have that plugged in when using it. My battery bank is 2 100 A lithium ion batteries...
  3. K

    Electrical fault - anyone?

    Hi, My sprinter is due for its mot soon, I have had a market light go out and it’s not the bulb. Im a complete novice with electrics but I tested the voltage with a multi metre and it was 0.01V, the marker light next to it was reading 13.7V and the connector is slightly burnt but still working...
  4. F

    Voltage drop on engine rev

    2014 Sprinter Diesel 3.0L with LTV camper on the back and 13K miles. Dealing with some low voltage error codes popping up and subsequent ABS/EPS/Traction control systems being flagged and disabled. Took a look at overall system voltage, so I put a multimeter on the system and noted 14.1v on...
  5. W

    Alternator Trouble - Low Voltage

    I have a 2012 Mercedes Sprinter 2500. I had a no start morning a couple times in the last few weeks and finally the battery would hold no charge. I took it in and was told it came back as need to replace, so I did so. Low and behold the van dies after a short drive. The new battery was not...
  6. Deancm

    Autopsy: Infamous "Y" cable from alternator to starter to battery

    I have a NCV3 2500 3L V6 built June 2008. As preventive maintenance I replaced the infamous "Y" Cable. Attached are photos of the old cable and one of the newly installed cable. 1. Shows the 300 Amp fuse shrink wrap cut open. There is a serious design problem here. Note where my fingers are...

Top Bottom