glow plug controller

  1. D

    Glow Plug Error Code Circuit/Open

    Got my first Check Engine Light as a sprinter owner and I'm hoping this one isn't too bad of a fix. Scanned it with my Autel 808 Pro and it came back with just one code P0675 Cylinder 5 Glow Plug Circuit/Open. Did some searching on the forums here but most people were getting codes for more...
  2. M

    P0670 Code After Y cable Change out

    I lwanted to pass on my learning experience. I changed out the Y cable which was bad and then I started getting several codes. I replaced the MAP and the code cleared I replaced the MAF sensor the code cleared. I then still had P0670 bad Glow Plug Controller and P2270 bad O2 sensor. I...
  3. J

    2008, 311 Sprinter - Fault Codes

    Hi, New to the forum, hope you're all well. Recently, my van has started to take longer and longer to turn over on start up and when it does there is a bit of white smoke that come out the exhaust for a few seconds before clearing up then it runs fine. It is cold here in the UK at the moment...
  4. J

    Glow plug / controller adventures

    Long-time listener first time caller. Summary of issue: 2004 long and tall sprinter RV (sportsmobile) 90,000 miles, second owner. Everything runs and functions correctly. Even colder weather cranks and runs OK. I live in Minnesota. But I generally don’t run the rig in the winter...
  5. B

    UPDATE: No Start: Key Turns, only 'one-click' under dash relay M

    Hi all, 2007 NCV3 Dodge Sprinter 180a alternator Factory installed Auxiliary battery. 2x 6 month Exide AGM Batteries. Most Recent trip: 5-18-2016 2500 mile FL to MA. CODES: MD802 Autel code 2267-1 Stored & Current N1 4/3 (Glow output stage) -Communication Fault MAINTENENCE RECORD: New...
  6. quillaja

    Can bad module ruin good glow plugs?

    I have been reading various threads about glow plug and module errors. I strongly suspect one or (most likely) more of my glow plugs are faulty. Or the module is. Or <insert one of 1,000,000 stupid things that could break>. Symptoms are difficult starting below 40F, very difficult starting below...
  7. V

    6 Codes Related to Glow Plug Circuit

    When I scan my van it gives me 7 codes: p0675 Cylinder 5 Glow Plug Circuit* p0672 Cylinder 2 Glow Plug Circuit* p0671 Cylinder 1 Glow Plug Circuit* p0380 Glow Plug Circuit Perf p0674 Cylinder 4 Glow Plug Circuit p0673 Cylinder 3 Glow Plug Circuit* p2506 ECM/PCM Power Input Signal Range/Perf_...
  8. R

    U0106 Code - CEL on and Intermittent Glow Plug Light

    About 9 months ago I got a P0675 code. The glow plug light would go out and then after starting the truck the light would reappear. I tested the glow plugs and found that the one on cylinder 5 was open so I replaced it and all was fine. Now the CEL is on again with a U0106 code. Now at...
  9. T

    Ongoing Glow Plug Failures? Controller Info:

    I've had ongoing Glow Plug Failures for 2+ years. (2007 Sprinter 2500 with 3.0L Engine) Long story, short, this is what I learned: -There are TWO Glow Plug CONTROLLER STYLES for the 2007 Sprinter 2500 3.0 L Engine. -One is for CERAMIC GLOW PLUGS, with a HIGHER VOLTAGE. -The other is for STEEL...
  10. T

    Continuing Glow Plug Failures

    I've got a 2007 Sprinter with repeated Glow Plug failures. History: May 2012: #1 Glow Plug replaced. May 2012: #6 Glow Plugs replaced. June 2012: Replaced Glow Plug Control Unit. July 2012: #2, #3, #4, #5 Glow Plugs replaced (as a precaution to prevent future failures of old glow plugs). Jan...

Top Bottom