Installed some of the wall plates.
The following picture shows two outlets that will be in an overhead cabinet in the right rear over the galley. Left outlet is for audio/video wires going to the TV from a DVD/Blu-ray player, and maybe a Satellite receiver that will be in the cabinet. Wires hanging are: HDMI to TV; 12V power; Audio/video to dash head unit AV2-in. Inside the box there is an A/B switch to select between cable and antenna for the TV. Power for the devices is on the right. This 15A AC circuit continues over the ceiling and to the refrigerator and a convenience outlet on the left side of the van.
Picture below. TV outlet and TV arm located at the top of the wall behind the sliding door. The TV arm is secured directly to the van chassis with three 1/4-20 rivet nuts installed through an area of doubled up sheet metal on the interior of the C pillar.
Wires coming out of the box are TV connections for:
12V power (it's an AC/DC TV but only using DC)
HDMI cable from outlet in previous picture
Audio/Video IN from dash mounted Head Unit AV OUT
Audio OUT to HU AV2 IN for piping TV sound through the speakers system.
RF IN from A/B switch in previous picture
rocker switch is to completely power down the TV (no lights).
(I have a hand drawn diagram of all this in my build folder - so it's documented.)
Next picture is the GFI outlet that will serve the galley. And in the lower panel, two boxes where all AC and DC circuits exit the wall. The
electrical chassis will be bolted to the floor there. Also shown is the programmable thermostat for the floor heat plugged into a dedicated GFI 15A 'electric heat' circuit. I'll also use this outlet for a small space heater. The other outlet in the picture is for a microwave oven that will be located in the galley cabinet. All the lower boxes still need face plates put on them.
Below: Computer rendering of the galley module (not yet finalized).