Blower Motor Resistor - Sprinter-Forum

Sprinter Fred · 10-27-2009, 06:06 PM

I recently purchased a used 2006 Dodge Sprinter. The blower motor only runs on 4 (high). I read that the blower motor resistor may be bad. Anyone know where it is and what it looks like?

Scott_Mc · 10-28-2009, 01:32 PM

FRED!

Under the hood, left of center (pass side), top, under the insulation. You'll see the flat wiring connector going into it from above. Simple, simple to change.

Aqua Puttana · 10-28-2009, 01:41 PM

Fred,
This is how I did it.

http://sprinter-source.com/forum/sho...0&postcount=11

About a 10 minute job. The original thread is available in the upper right corner. Hope this does some good. AP/vic

Sprinter Fred · 11-13-2009, 08:49 PM

I just got around to replacing the resistor. Just as Aqua Puttana said. Now if have all speeds working on the blower. The link in gggary was a great help

Thanks much!

Ancote · 09-08-2010, 04:25 AM

It is located, under the hood, just at the right of the motor.

on the left of the cabin filter, easy to replace

Andre from Montreal PW TS 06

Quote:

Originally Posted by Sprinter Fred

I recently purchased a used 2006 Dodge Sprinter. The blower motor only runs on 4 (high). I read that the blower motor resistor may be bad. Anyone know where it is and what it looks like?

Aqua Puttana · 09-10-2010, 02:54 PM

Quote:

Originally Posted by Ancote

It is located, under the hood, just at the right of the motor.

...

It is located, under the hood, in the duct housing, just to the right of the fan blower motor.

Not to the right of the diesel engine.

vic

Nautamaran · 01-29-2017, 04:32 AM

Six years on this is still a useful thread!
Did mine this morning, as January is no time to be without a heater fan.
10 minute job, including knocking the loose dust out of the cabin air filter.
(CAD$40 for the filter buys a lot of canned air...)

Crew chief · 12-11-2017, 04:28 PM

Quote:

Originally Posted by Scott_Mc

FRED!

Under the hood, left of center (pass side), top, under the insulation. You'll see the flat wiring connector going into it from above. Simple, simple to change.

Can you show a picture of this on a 2008 Sprinter 3500 diesel please? Thank you!

Goofy foot · 12-11-2017, 08:16 PM

Not sure if Blower motor /resistor is in same location on an NCV3 (2008) van as on this threads T1Ns (06 and earlier years).

DesertAdventures · 12-11-2017, 08:44 PM

Quote:

Originally Posted by Nautamaran

Six years on this is still a useful thread!
Did mine this morning, as January is no time to be without a heater fan.
10 minute job, including knocking the loose dust out of the cabin air filter.
(CAD$40 for the filter buys a lot of canned air...)

Have been detailing my newly purchased 04 Sprinter and have found a leaf blower to be super helpful.

10-27-2009, 06:06 PM	#1
Sprinter Fred Join Date: Oct 2009 Posts: 2 Thanks: 1 Thanked 0 Times in 0 Posts	Blower Motor Resistor I recently purchased a used 2006 Dodge Sprinter. The blower motor only runs on 4 (high). I read that the blower motor resistor may be bad. Anyone know where it is and what it looks like?

10-28-2009, 01:32 PM	#2
Scott_Mc Sprintering Since Aug/02 Join Date: Nov 2006 Location: Jamaica Plain, MA Posts: 821 Thanks: 133 Thanked 106 Times in 89 Posts	Re: Blower Motor Resistor FRED! Under the hood, left of center (pass side), top, under the insulation. You'll see the flat wiring connector going into it from above. Simple, simple to change. __________________ *I still* like...(used to love)my T1N My Ride: Factory Order, Early`03 Freightliner version 140" SHC NO WINDOW Cargo version in Blue-Black presently @ 170,000 miles... RUNS like 25,000 miles....LOOKS like 1/2 a milllion... Thank you** Mercedes for the substandard paint prep & corrosion prevention throughout. My '99 Audi Avant, 4 years older and 15K more miles...ZERO RUST.... You got me once!

10-28-2009, 01:41 PM	#3
Aqua Puttana Poly - Thread Finder Join Date: Apr 2008 Location: The Falls of Niagara, USA Posts: 25,193 Thanks: 12,976 Thanked 14,246 Times in 9,042 Posts	Re: Blower Motor Resistor Fred, This is how I did it. http://sprinter-source.com/forum/sho...0&postcount=11 About a 10 minute job. The original thread is available in the upper right corner. Hope this does some good. AP/vic __________________ DAD NAS (N. Amer. Spec) 2004 140 2500 >330,000+ mi. ~~Arctic Whitewash~~ Brush-tone Grey 2006 Freightliner 140 2500HC >183,000+ mi. Arctic Whitewash (Spotted Snow Leopard accents) "My opinion and worth everything you'll never pay for it." assumed. Anyone can hold the helm when the sea is calm. Publilius Syrus "There are only 10 types of people in the world: Those who understand binary, and those who don't." HaWiiLuVeR 16 ounces of unnecessary prevention can be worth a pound of manure.

11-13-2009, 08:49 PM	#4
Sprinter Fred Join Date: Oct 2009 Posts: 2 Thanks: 1 Thanked 0 Times in 0 Posts	Re: Blower Motor Resistor I just got around to replacing the resistor. Just as Aqua Puttana said. Now if have all speeds working on the blower. The link in gggary was a great help Thanks much!

01-29-2017, 04:32 AM	#7
Nautamaran 2004 140” SHC U.S. T1N Join Date: Jan 2017 Location: Calgary, AB Posts: 2,681 Thanks: 925 Thanked 1,803 Times in 1,204 Posts	Re: Blower Motor Resistor Six years on this is still a useful thread! Did mine this morning, as January is no time to be without a heater fan. 10 minute job, including knocking the loose dust out of the cabin air filter. (CAD$40 for the filter buys a lot of canned air...)

12-11-2017, 08:16 PM	#9
Goofy foot sliding left... Join Date: Apr 2012 Location: Morro Bay,Ca Posts: 518 Thanks: 277 Thanked 167 Times in 131 Posts	Re: Blower Motor Resistor Not sure if Blower motor /resistor is in same location on an NCV3 (2008) van as on this threads T1Ns (06 and earlier years). __________________ 2006 T1N 158" SHC 2500 cargo... Brembo ceramic pads on Zimmerman rotors Bilstein struts/Fox shocks Michellin LTX M/S2

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode