P0100 and P0102

Hi,

Dodge sprinter 2500 2006

i get an engine light on today. and get a p0100 and p0102, MAF code then clear the codes.

when disconnect and reconnect the contact wire at the MAF and those going on pipe after the turbo, no engine light.

when start engine 30 mins after the engine light on again.

What strange, i set my OBD MAF on dial and get 303.5 constant, no change when press the accelerator.

OBD MAF set to graphic get about 270 and climb to 290 then back at 270 and repeat with no change when press accelerator.

also maybe a coincidence but this happen when a load about a 1000 lb.

could it be only need a MAF cleaner ? or more serious.

i forget that i well clean the electrical contacts when get a turbo problem.

Thank's

mickal

Did you get this worked out?

Did you solve the problem?

bill in tomahawk

Yes solve,

a good cleaning of the MAF, after 3 start cycle the engine light does not come on, and hope it will stay off.

thank you

Mickal