Sprinter-Forum    
 

Go Back   Sprinter-Forum > Sprinter-Based RV's & Conversions > Sprinter-Based RV Brands > Leisure Travel Vans > Unity


 
Thread Tools Display Modes
Old 07-12-2019, 12:00 AM   #11
woundedpig
2018 Unity MB
 
Join Date: Aug 2009
Location: Austin, Texas
Posts: 674
Thanks: 100
Thanked 383 Times in 230 Posts
Default Re: AC cycles over and over?

I think the 1 or 2 degree differential function is only relevant for the furnace mode.

From the manual:

“In the FURNACE mode the system will cycle the RV’s furnace On and Off based on the room air temperature and the temperature set-point on the Single Zone LCD thermostat. The system can be configured to operate using an On/Off differential of either 1 degree F or 2 degree F. This feature is programmed during the system initialization. See “System Initialization” on page 3.

To set the temperature differential the system must be Off. Press the “―” button and, while holding it, also press and hold the On/Off Mode button for three seconds. Release the On/Off Mode button. Then release the “―” button. Press the “+” button to toggle between “d1” and “d2”, “d1” for 1 degree F differential and “d2” for 2 degrees F differential.“
woundedpig is offline   Reply With Quote
The Following User Says Thank You to woundedpig For This Useful Post:
hotfudge (07-12-2019)

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT. The time now is 08:03 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.