Sprinter-Forum    
 

Go Back   Sprinter-Forum > T1N Sprinters > T1N Write-Ups

T1N Write-Ups Help other T1N owners by posting your experience working on your Sprinter.


 
Thread Tools Display Modes
Old 10-30-2019, 02:21 PM   #1
veganxxx
 
Join Date: Jan 2010
Location: Braddock PA
Posts: 250
Thanks: 0
Thanked 111 Times in 60 Posts
Default Oil pan replacement

I just replaced a cracked oil pan for a customer.

1. pull the front bumper
2. put the van on the lift and lift up a few feet
3. Take an engine hoist and attach to the front lifting point
4. Remove both engine motor mount bolts (18mm if I remember correctly)
5. Jack up the engine until the rear touches the top of the fire wall
step i forgot to write- unplug oil sensor harness
6. Unbolt and pull down wiring harness that runs across rear bell housing
7. Remove the oil pan bolts (2 different E torx sizes)
8. Remove the transmission bolts that go through the oil pan (even bigger E torx)
9. Once pan hangs down tilt it to one side.
10. Between the pan and block remove the oil pickup tube bolts
11. Tilt the pan to the other side
12. Remove remainder of oil pickup tube bolts (4 in all)
13. Pull pan and oil pickup tube towards front of van
14. clean up the gasket surface area
15. small amount of silicone to glue new gasket to new pan and transfer oil sensor to new pan.
16. put the pan and pickup tube under the block
17. reinstall pikcup tube
18. Start a couple pan bolts for alignment
19. Install the rest of the bolts
etc etc until it's done!
veganxxx is offline   Reply With Quote
The Following 3 Users Say Thank You to veganxxx For This Useful Post:
Aqua Puttana (10-30-2019), autostaretx (10-30-2019), Midwestdrifter (10-31-2019)
Old 10-30-2019, 02:40 PM   #2
lindenengineering
 
Join Date: Dec 2009
Location: Littleton Colorado
Posts: 12,718
Thanks: 3,133
Thanked 10,689 Times in 5,432 Posts
Default Re: Oil pan replacement

How many hours to do it that way?
Dennis
lindenengineering is online now   Reply With Quote
Old 10-31-2019, 02:11 PM   #3
veganxxx
 
Join Date: Jan 2010
Location: Braddock PA
Posts: 250
Thanks: 0
Thanked 111 Times in 60 Posts
Default Re: Oil pan replacement

From putting the van on the lift to having the pan on the shop floor took 2 hours.

Cleaning everything and carefully putting all the bolts back in took 3.5 hours.

Also I should mention the new pan (customer provided) did not have threaded holes for the oil sensor. Part of the time was tapping these three holes for the M6 torx bolts. A fact I only realized after the pan was mounted on the vehicle. That alone was probably half an hour or so, mainly because I didn't have a bottoming tap (needed since the holes are pretty shallow) and had to make one from a regular tap with some bench grinder action.
veganxxx is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT. The time now is 09:32 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.