Go Back   Sprinter-Forum > T1N Sprinters > T1N Write-Ups

T1N Write-Ups Help other T1N owners by posting your experience working on your Sprinter.

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-26-2019, 01:43 AM   #1
'02 140 Hi BlueBlk Pass
Join Date: Sep 2006
Posts: 2,680
Thanks: 591
Thanked 1,561 Times in 712 Posts
Default Rear Door Bumper Replacement

One of my rear door magnetic door bumpers rusted, causing the bumper to split and fall apart.

So I ordered a replacement. 05104370AA NOTE that the part bag does NOT come with the underlying gasket nor screws.

You would think that the two screws (3 mm Allens) would come right out. But not so. The splitting magnets put a torque on the screws such that they will not easily turn - threatening to strip out the Allen wrenches. So I used a hacksaw blade to cut the plastic. I used the new bumper to figure out where to cut.

But here is the tricky part. As with other mounts on the Sprinter (think strike latch on the sliding door), the mounting plate is located inside the door's casing - but free floating. If you take out both screws at the same time, the plate will fall into the casing never to be found again. Two pictures above shows one of the screws removed and you can see the mounting plate inside the door casing.

Mount one side of the new bumper before taking out the second screw.

Then remove the 2nd screw and finish mounting the new bumper.

hkpierce is online now   Reply With Quote
The Following 3 Users Say Thank You to hkpierce For This Useful Post:
autostaretx (06-26-2019), Nautamaran (06-26-2019), Skippy and Emu (06-26-2019)

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 02:21 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.