Engine number

Aussie 2002 4x4

Well-known member
very hard to spot...it's above the starter motor. i had to rub chalk into it - chalk on a long stick and then take a pic with an inspection camera on a long stick...otherwise a mirror from underneath

if it's the original engine then you can put your vin number in here and it will give you your engine number:

https://www.vindecoderz.com/

at least then if you see a partial number on your block you will know you are in the right place
 

Eric Experience

Well-known member
Man.
Just to be a bit more specific as to where the number is, it is on a machined surface running up at an angle along the block to bell housing junction it starts just above the crank angle sensor. Eric.
 

CJPJ

2008 3500 170 EXTD 3.0 V6 OM642.993 4.182
The engine # is on the block in two spots. One spot is topside behind the high pressure pump.
 

manddburgan

New member
Thanks to all. I found it to the left of the pressure pump and was able to clean the area and then mark it with chalk. Thanks again
 

Top Bottom