Sprinter-Forum    
 

Go Back   Sprinter-Forum > Regional Discussions > USA


 
Thread Tools Display Modes
Old 11-06-2019, 07:05 PM   #1
JHGould5607
 
Join Date: Jun 2015
Location: Bloomington MN
Posts: 28
Thanks: 7
Thanked 1 Time in 1 Post
Default Glow Plugs Job - Any mechanics in the Minneapolis?

I am need of new glow plugs and glow plug module replacement. Any recommendations in the Minnesota area?

I called around my area a lot of shops will not do the job.

A spoke with a very rude person at Ultimate Fleet Repair. Would not quote me a price for the job and also mentioned they do not guarantee sheering of the glow plugs.

Thanks!
JHGould5607 is offline   Reply With Quote
Old 11-09-2019, 01:15 PM   #2
lindenengineering
 
Join Date: Dec 2009
Location: Littleton Colorado
Posts: 12,578
Thanks: 3,095
Thanked 10,577 Times in 5,371 Posts
Default Re: Glow Plugs Job - Any mechanics in the Minneapolis?

Knowledge is power.
Book time quote is between 2 & 2,5 hours.
That quotation is based upon a minimal difficulty to remove them without busting them off !

It includes a possibility of a re-seal exercise around the intake system aft of the turbo etc.

Now the object is not to break them!
But it can happen so experience comes into play.
Question the shop service writer on things like how many have they successfully fixed /replaced?
Have they got any RECENT customer phone numbers to give you an idea of their skill.
If they have good workshop management program they should be able to whip you off a list of past customers willing to give you a referral.

Now in the case they do break ask them if they have the special tools to extract them.
If they don't--- run!
The best tools for the job are by Klann or Muller Vertzeug. If they don't have these tools at hand --run!

These tools are expensive and easily break.
The tool kit starts at $350 a set.
Now if we get vans/jeeps in with broken glow plugs the charge is $300 per hole.
Extra if someone has broken say a drill bit off or easy-out in the hole with ham fisted techniques . That then requires us to use a mini EDM machine or Dremel tool & diamond bit to cut it all out.
Its cheaper than lifting heads and bench work.

There is no hard and exact rule on successful extraction, time/patience/experience/preparation is a good aid to successful removal and not going at them like a bull at gate.
Hope that text is helpful to you.
Dennis
lindenengineering is online now   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT. The time now is 02:52 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.