So you are supposed to be able to move a scanguage between 2 different vehicles which I have only tried quickly in the garage. When doing so, I assumed that it would "remember" the settings of each vehicle, but apparently not. All the scanguage documentation says is that you can use it in multiple vehicles and you must wait for it to sleep before removing. It doesn't mention anything about resetting specifics for each vehicle. At a minimum, it seems I have to reset the tank and engine sizes, and fuel type every time I switch vehicles. Is this normal for using the scanguage on 2 vehicles or have I done something wrong? (I did wait for it to sleep). If it is normal, it would seem like it would be a challenge to get accurate gas mileage readings, estimates, etc. if switching frequently. Or should I just try it out in both cars few times and see?
thanks in advance.
Jonathan
thanks in advance.
Jonathan