Sprinter-Forum    
 

Go Back   Sprinter-Forum > Sprinter-Based RV's & Conversions > Sprinter-Based RV Brands > Airstream > Sprinter Westfalia


 
Thread Tools Display Modes
Old 11-19-2017, 07:57 PM   #11
dun_roamin
 
Join Date: Jan 2016
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Default Re: Power Window Fail

Here's what I ended up doing.

- 3d print the plastic part, 3d model found somewhere on this forum
- Bring the regulator to my garage, heat up 3d part until it stretched over existing rivet
- As part was a little malformed, use heat gun again on 3d part until it naturally fell back to its original shape
- Install regulator, use lots of grease, good as new!

Fingers crossed it lasts a few years.

Thanks for all your help!
dun_roamin is offline   Reply With Quote
Old 01-02-2018, 06:21 PM   #12
SondraRose
 
Join Date: Aug 2015
Posts: 9
Thanks: 31
Thanked 1 Time in 1 Post
Default Re: Power Window Fail

We bought the brass part off eBay mentioned in a previous post and used it very successfully!

We took the screws out of the regulator assembly and moved it slightly so we could get the slider into the window track, then screwed it back in. A ten minute job and $35. Yay!
SondraRose is offline   Reply With Quote
The Following User Says Thank You to SondraRose For This Useful Post:
OldWest (01-05-2018)

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT. The time now is 05:29 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.