Thread: Overland Build
View Single Post
Old 07-30-2015, 02:22 AM   #7
Join Date: Sep 2013
Location: Roaming Out West for a While
Posts: 7,402
Thanks: 1,336
Thanked 4,976 Times in 3,099 Posts
Default Re: Overland Build

Here are some pictures of the galley construction.

I used 1/2" plywood and 1x2" poplar stock for the front face.

Here we have it test fitted.

All the OEM floor rivets have been replaced with 1/4-20 rivnuts. I am using many of these to mount cabinets.

The ceiling is covered with 5mm plywood.

I used plastic h molding for the joints, and FGRP for the curved sections.

The bench seat is made from 1/2 and 3/4" plywood. I used aluminum extrusions and wooden gussets to provide support where needed.

Due to the bump out aft of the slider door, the bench seat ended up being a tight fit. It requires some gymnastics to get in place.

Here is the interface with the galley.

2004 T1N | Overland Conversion in Process Completed...For now... | 101,000 118,XXX 137,078 165,000 miles | 140" | High Roof | My Build Thread
Another Random Blog |
Midwestdrifter is offline   Reply With Quote
The Following 5 Users Say Thank You to Midwestdrifter For This Useful Post:
CC_Rider (08-23-2016), DesertAdventures (11-10-2018), King_1223 (07-01-2016), melzmelz2 (04-14-2016), outwestbound (06-03-2018)