View Single Post
Old 09-19-2018, 04:24 AM   #8
T1N Westfalia
CaptnALinTiverton's Avatar
Join Date: Dec 2011
Location: Tiverton, RI
Posts: 139
Thanks: 50
Thanked 19 Times in 19 Posts
Default Re: Replacing Propane detector

You may be able to fish the existing wires out of the hole with long nose pliers. If you get them through enough you can affix either butt connectors or blade connectors to the wire ends (female on power wire, male on the ground wire) to connect to two new wires from new detector with butt/blade connectors affixed (male on power wire, female on the ground wire). Then slide the those back through the hole and mount the detector in same place with small stainless wood/sheet-metal screws. That's how I did it.

CaptnALinTiverton is offline   Reply With Quote