View Single Post
Old 09-18-2018, 07:31 AM   #6
OldWest
T1N Westfalia
 
Join Date: Jul 2009
Posts: 2,124
Thanks: 217
Thanked 633 Times in 481 Posts
Default Re: Replacing Propane detector

Hard to visualize exact situation.

So connector is too big to fit through existing holes

But is there sufficient slack of the hidden wires (extra length) on the other side of connector where you could pull the wires through existing holes (and just cut the connector to fall behind and make new splices/connector)?

Or could you smash the connector with needlenose pliers or a dremel to make it small enough to fit through holes?

In any event, it'd be nice to be able to disconnect the propane detector easily (although that may not meet RVIA or other standards).

Last edited by OldWest; 09-18-2018 at 07:33 AM. Reason: Add last sentence.
OldWest is offline   Reply With Quote