View Single Post
Old 11-08-2013, 04:43 AM   #139
hein
Van Guru
 
Join Date: Jan 2011
Location: PacNW
Posts: 2,259
Thanks: 1,361
Thanked 1,750 Times in 983 Posts
Default Re: 2010 3500 RV build

Below is a picture with some of the holes circled. I'm not sure if they are used with the factory panels. I did not modify them to work with the push pins. I'll need 86 of the pins for my van.



The lower panels in my van were formerly installed with sheet metal screws. I treated all those screw holes with a rust preventative. Some I sealed with 3M fast set urethane since they were right at the top of the drain channel along the bottom. They would let water in to the floor area before I sealed around the trim rivets. See post #50
__________________
2010 MB 3500 RV conversion.

Last edited by hein; 11-08-2013 at 04:47 AM.
hein is offline   Reply With Quote
The Following 2 Users Say Thank You to hein For This Useful Post:
Hartusi (01-03-2016), wiartonallan (11-14-2013)