View Single Post
Old 01-06-2019, 08:12 PM   #14
damien89
 
Join Date: Mar 2009
Posts: 83
Thanks: 32
Thanked 8 Times in 8 Posts
Default Re: Anyone managed to connect a scan gauge to 16+ sprinter?

Quote:
Originally Posted by Winterbagoal View Post
One more quick question. Is the key in the "RUN" position, or the engine running, when you get the never ending "Connecting" message?

FORCE/SELECT THE PROTOCOL:
You'd have to connect to a different vehicle with it, or it could be powered by the OBDII that it won't connect to. (I think? never tried it)
Then press "MORE" then "MORE" then "MODE".
Using the left and right arrow buttons, you can scroll through the available list of protocols that the SGII supports.

From the SGII manual troubleshooting section:

Never stops saying
“Connecting...”

Vehicle ECU not on Turn key to RUN or start engine <<<<

ECU not responding properly

Use MORE>MORE>MODE and try
Forcing the following modes:
FORD Products: PWM or CANSF
GM Products: VPW , ISO or CANSF
Chrysler Products: ISO, VPW or CANSF
Volvo Products: ISO, CANSF or CANLF
Others: ISO, KWPS, KWPF, CANSF,
CANLF, CANSS or CANLS

Where to Get Support

Online: www.ScanGauge.com/support
www.facebook.com/ScanGauge
Toll Free: 1-888-433-5664
E-mail: support@linear-logic.com
Yeah i tried all that even with the engine running, stays in the connecting screen then shuts down.
__________________
2017 Sprinter 516cdi OM 651 7G-Tronic LWB 'LongTail'
damien89 is offline   Reply With Quote