View Single Post
Old 04-24-2016, 10:00 PM   #1
Join Date: Dec 2006
Location: Benson Arizona
Posts: 271
Thanks: 58
Thanked 185 Times in 112 Posts
Default Central electronics control/display panel push button repair

It has gotten to the point where I have to press VERY HARD for the buttons to make contact.
After a few hours of researching possible solutions I finally chose this one.

1) Clean black contact pads with isopropyl alcohol to help promote good adhesion.

2) Cut up a small square of adhesive backed aluminum foil tape.

3) Position tape on top of black contact pad using a pair of tweezers.

3) Press HARD with thumb for 20 seconds to help promote good adhesion.

It now takes very little pressure to activate the buttons.
Only time will tell if the little aluminum squares stay adhered.

Attached Images
File Type: png Screenshot 2016-04-24 at 1.14.11 PM.png (146.7 KB, 130 views)
onemanvan is online now   Reply With Quote
The Following 2 Users Say Thank You to onemanvan For This Useful Post:
luvwagn (07-04-2019), westyventures (11-12-2019)