View Single Post
Old 06-23-2019, 11:09 AM   #22
feynmanfan
 
Join Date: Aug 2018
Location: Cincinnati
Posts: 76
Thanks: 49
Thanked 54 Times in 26 Posts
Default Re: easy fix for water leaks on side body panels

The gasket (extrusion on my world) is from 8020. That said, note that they offer a few versions depending on the aluminum extrusion system. The original video (OP) used 2115 and that is what I used. Others have used different profiles with success. I can not comment on which is best/easier to work with. I can point out that I did not trim. I did notice the van's panel clips were close to the trim so a longer trim leg may need trimming. I attached a few profiles for ref. Also note the TPE (thermoplastic elastomer) versus silicone decision. It I get ambitious, I may buy a section of everything that makes sense and perform a "review".
Attached Images
File Type: jpg 2117.jpg (19.1 KB, 87 views)
File Type: jpg 2177.jpg (18.2 KB, 84 views)
File Type: jpg 2178.jpg (12.4 KB, 85 views)

Last edited by feynmanfan; 06-23-2019 at 11:38 AM.
feynmanfan is offline   Reply With Quote