View Single Post
Old 07-27-2015, 10:20 PM   #5
Join Date: Mar 2015
Location: Oregon
Posts: 14
Thanks: 1
Thanked 14 Times in 7 Posts
Default Re: factory seat location options

2015 144 Crew. Removed the existing seat, seat mounts, and wood floor. Measured exactly 858 mm from the first set of holes, drilled very carefully with a step bit ..... there they were, factory nut plates! Measure twice cut once on the wood floor, i was off just a bit and had to pull it out again and trim. Also get yourself a good set of Torx bits for a 3/8 ratchet (you'll need a T50 to pull the cargo mounts to get the floor out). Wife kid and dog like the 2nd position for just hanging out. Good luck!
Attached Images
File Type: jpg FullSizeRender.jpg (116.9 KB, 477 views)
File Type: jpg IMG_1139.JPG (138.6 KB, 453 views)
File Type: jpg IMG_1142.JPG (89.5 KB, 426 views)
File Type: jpg IMG_1143.JPG (108.8 KB, 439 views)

Last edited by WoodfordDog; 07-27-2015 at 10:23 PM.
WoodfordDog is offline   Reply With Quote
The Following 3 Users Say Thank You to WoodfordDog For This Useful Post:
drivescarswell (01-11-2019), LukeI (11-04-2017), Onefin (07-28-2015)