I am occasionally getting an implausible right rear wheel speed sensor code on my 2006 T1N (140,000 miles). I have done a resistance check at my ABS pump and all of my wheel speed sensors read in the 1.8-1.89 kOhm range (which is on the high side according to the service manual). I also checked the right rear wheel speed sensor resistance at the splice area in front of the rear axle and got almost identical resistance readings (clearing bad wiring or a bad splice from the picture).
Is it typical for the wheel speed sensors to have these higher resistance readings?
I have also viewed live wheel speed data with Xentry and it appears that I am getting good data. I have not had the luck to view the live data when the dash lights illuminate
Any insight on this one?
Is it typical for the wheel speed sensors to have these higher resistance readings?
I have also viewed live wheel speed data with Xentry and it appears that I am getting good data. I have not had the luck to view the live data when the dash lights illuminate
Any insight on this one?