Replacing fuel rail pressure sensor.

Isla

Member
Quick question on removal. I need to remove the sensor and pull a part number off it because apparently the om612 uses two different rail a sensors, switched mid year. Is there any tricks for me to know which one it is without removing it entirely? Also when i go to remove will fuel leak out causing priming issues? I assume not because of its location in the fuel system but i don't know. Thanks guys


Sent from the first city on the Mississippi.
 

NelsonSprinter

Former Nelson BC Sprinter
The fuel rail pressure sensor is on the front end and easily visible for the part #.
The fuel rail's pressure solenoid/regulator is on the far end , and both should wait 1/2 hr after running before removal to dissipate pressure IMHO
 

Top Bottom