need source for new pistons, bearings etc. for 2007 3.0 engine

I need the best lead on Sprinter engine parts.

I need the following

Rod bearings standard

(2) red lower main bearings
(2) white lower main bearings
(4) upper yellow bearings

(12) rod bolts

head bolts all

Left and right head gaskets

Piston rings

This should put my 2007 engine in solid form

MB Dealer
Only yellows were available in NA the last time I checked & rebuilt

Prices are fair for the listed items at OE retail.
Dennis

lindenengineering said:

MB Dealer
Only yellows were available in NA the last time I checked & rebuilt

Prices are fair for the listed items at OE retail.
Dennis

Click to expand...

I googled the OEM Mb part number and then hit "Shopping" tab...


There are some good deals if one matches Doge parts and MB parts

The MB has whites for $25.00

Once I get the 2013 engine straightened up, I will see about the 2007 rebuild parts

I am looking forward to polishing the exhausts and port matching to the exhaust manifolds. I think all I will do to the intakes is port match to the intake manifolds

I think the GL350 rings will work at $108 a piston for rings.

I look foward to building this bottom end back up. All the seals were new...

One head has 30,000 miles on while the other has 150,000. I may have to source a 30,000 mile head or use my Neways on the valves and seats. The guides seem to not wear that bad on this cylinder head.


Thanks Dennis