PDA

View Full Version : Fiamma F65 Awning on a Fake Crafter


ctmcdaniel
04-07-2008, 09:21 PM
The adapter brackets for the sprinter require removing the load track
7054


the troublesome middle bracket
7055


Middle bracket again, the left side of the bracket hit the roof top
I had to file about 3/16" of aluminum off to make it fit flat
so there was no gap at the bottom.
7056

Rear bracket
7057

7058

ctmcdaniel
04-07-2008, 09:39 PM
The Crafter hospital
7059

Center or B support after I filed down the edge
Sikaflex 252 is the black stuff... I have 2 extra tubes of this
Very sticky
7060


Another view of the B support again you can see were I
filed down the left edge if you compare it to the other pictures.
7061



Back of the front support
7062


Back of the Rear support
7063

ctmcdaniel
04-07-2008, 09:45 PM
It looks less intrusive then I thought it would
7064

7065

7066

7067

7068

Tom McD

sikwan
04-08-2008, 05:56 AM
Nice addition Tom. That really matches the Van. :clapping:

Fiamma4us
04-15-2010, 02:49 PM
Fiamma now has brackets that will mount directly to the rail. So you dont have to remove it. By the way nice photo's it looks very good.:clapping:

Legwound
08-14-2012, 01:46 AM
I have an almost identical van

which model of f65 do you have? (what length, etc)