PDA

View Full Version : Following codes 2359, 2953, 2355


hksnlper
04-28-2013, 02:03 AM
Just put in a used engine in my sprinter with around 38k miles. The truck runs good for 15 min and then goes into limp mode If I clear it with the Star 1 machine and drive the truck it runs fine for about 15 min and then it goes into limp mode again. No turbo no boost. Seems like a DPF issue. Open to ideas and suggestions. I get the following code 2359, 2953, 2355

hksnlper
04-30-2013, 02:47 AM
any input guys

Vander
05-03-2013, 08:38 PM
Code 2359 Charge Pressure Control-Too Low boost pressure
Code 2953 Right EKAS end position Measurement sensor- (either Valve is closed and readout too large or Valve is open and readout too small=same code.
Code 2355 Exhaust gas recirculation control- Exhaust gas recirculation rate too high or too low=same code.
Can you actuate valves with that machine? If you can, then you can perform actuation tests to test the EGR and EKAS valves.

hksnlper
05-05-2013, 05:05 PM
I did perform actuation test and it looks like the valve open and close. Except the right side, That's the only side which value never changes

hksnlper
06-29-2013, 07:01 PM
Solved the problem. The Plastic tab was broken so had to replaced the complete Manifold.