Engine Problem

Have a 06 2500 with 86000 on it - the engine will die for a split second then come back while driving down the road. The service center has replaced the fuel filter, replaced 1 of the injectors, replaced the crank sensor & it is doing the same thing. After getting back from service the engine was doing the same thing again & light came on again so I plugged in my code reader - came up with a crank sensor prefomance code again - reset the code & drove it. Not getting any codes or engine light but it is still momentarily dies & comes back.
Not getting any fuel pressure codes or any other codes for that matter except for the crank sensor preformance. The service center is getting frustrated as I am - Does anybody hace any ideas or direction on what to look for ? Would really appreciate the input or help.

Tom

Hi Tom,
What is the code, and what sort of Scanner/code reader are you using?
If it's not a DAD (Dr. A Diagnositcs) or a Factory DRB-III the codes may
be meaningless as far as diagnosing a Sprinter.
The ScanGuage II and Dash DAQ will develop codes, but they only point
in the direction of the problem most of the time.
DAD or DRB-III are "Sprinter specific" and can be trusted to identify actual
problems with the sensors and electronics found in T1N Sprinters.
Not good news I know, but it's the reality.
Roger

tom leasure said:

the engine will die for a split second then come back while driving down the road.

Click to expand...

If it's not driving down the road, will it still die for split second and continue to run or will it completely die?

A total shot in the dark, but maybe not too hard to check. vic