PDA

View Full Version : Rear door panel removal NCV3 w/windows


Mrdi
06-29-2010, 02:37 PM
Unable to find directions for rear passenger door panel removal.
I have the plastic panel below the windows that has the net and storage area.
Already snapped one clip.

Thanks

jdcaples
06-29-2010, 02:43 PM
There might be better information on www.sprintertekinfo.com, but this is all I have for now:

-Jon

Mrdi
07-03-2010, 03:23 PM
Popped the drivers side rear door panel upper corner away from the door. It appears the orange plastic
fastener remains in the door and a U shaped plastic part that fits over the round circle fastener has come away with a SNAP. It looks as though the panel should be lifted.
I'm reluctant to snap anymore of these away.
Suggestions welcome.

Thanks

Graphite Dave
07-03-2010, 08:56 PM
I have the same question. I also have one corner pulled loose and was afraid to proceed. Maybe we are not alone! I did figure out how to remove the overhead light fixtures and sliding door panels. Two out of three is not all bad.

twistyroad
07-06-2010, 07:16 PM
Read this thread (http://sprinter-source.com/forum/showthread.php?t=3716). It's about the front door panels, but the rear panels attach the same way.