Aircraft Wrench
New member
I have been searching for posts on how to install a "Generic" trailer lighting converter (powered type) and remember someone recently posting how this was accomplished and had mounted the controller command relay modual under the left taillight assy.....I CAN NOT FIND THE POST
I should be at by you guys as much as possible!!! I am hoping to not have to extend the too short wires from the module to each side of the van....is there a wiring run on the left side that I can "Tap into" for both turn signal lights?
BTW I did the Sikwan deal and got a hitch from JC Whitney...had it modified for an additional receiver at each end...now I'll have a custom tray/bike holder made....I will post pic of the hitch tomorrow ....
Thanks for the help!!
Best regards,
Mr "I'm functioning well for an 8 year old" Jimmy
I should be at by you guys as much as possible!!! I am hoping to not have to extend the too short wires from the module to each side of the van....is there a wiring run on the left side that I can "Tap into" for both turn signal lights?
BTW I did the Sikwan deal and got a hitch from JC Whitney...had it modified for an additional receiver at each end...now I'll have a custom tray/bike holder made....I will post pic of the hitch tomorrow ....
Thanks for the help!!
Best regards,
Mr "I'm functioning well for an 8 year old" Jimmy