windsprinter
New member
Many of the plastic components - especially tabs - seem to be really brittle on my Sprinter. I've snapped almost all the thin parts I've touched, starting with the cover for the OBD bus when installing my scanguage. THen the plastic attachment points on the handbrake cover all broke off Several other scenarios for little bits and pieces. I'm not usually particularly ham-handed, and seem to have had more than my share of breaking things in the Sprinter.
Latest was changing a headlight bulb. Read the manual, opened the hood, read the manual again, OK two little clips to undo, very little pressure needed to release them - and one of the danmm things broke! I kept the tab after I found that it was $68 for a new plastic cover (this is inside the engine compartment). I'm not confident it will stay waterproof without the part, so I'd like to fix it.
Two questions; 1) anyone else have this problem? ; 2) anyone know a suitable glue to try?
Thanks
Morley
Latest was changing a headlight bulb. Read the manual, opened the hood, read the manual again, OK two little clips to undo, very little pressure needed to release them - and one of the danmm things broke! I kept the tab after I found that it was $68 for a new plastic cover (this is inside the engine compartment). I'm not confident it will stay waterproof without the part, so I'd like to fix it.
Two questions; 1) anyone else have this problem? ; 2) anyone know a suitable glue to try?
Thanks
Morley