doctorlock
New member
This question must have been asked before, but.... Is there a print or software with pictures and locations of the various sensors covered by DAD. I'm very new to working on my '04 HT. Thanks, Bill
is the DAD tool still available do you know ?The last few pages of the Wiring Diagram section (8W) of the Service Manual also shows many sensor locations.
(as do the detail pages throughout the manual).
2003: http://aie-services-2.net/Sprinter/05 service manual.pdf
2006: http://aie-services-2.net/Sprinter/2006-VA-SM.pdf (better diagrams)
--dick
i don't know... ask Andy: 412-366-6165is the DAD tool still available do you know ?
If i were to hazard a (pure) guess, i'd suspect a damaged/slightly-dislodged wheel-speed sensor (one at each wheel, watching the slotted disk)2 warning lights keep coming up on the dash after about 5-10 minutes driving. the traction control and another warning light. it happens in all road and weather conditions after 5-10 minutes driving used a odbii diag tool but its not showing any codes
According to what Dr. A told me, the DAD is no longer available.is the DAD tool still available do you know ?
I thought maybe a DRBIII off eBay would be worth pusuing, but didn't bother because fortunately I do have the DAD and that does what I need. A recent discussion with Doktor A (I have yet to meet that gentleman face to face, but we have had many pleasant and productive, for me, phone conversations) verified that a used DRBIII is probably not worthwhile for DIY purpose. I know you need an optional card and cable to make the unit work with a Sprinter. What Andy clued me into was that not all models accept that card so it may need to go back to the factory for upgrade. When it gets to the factory it often needs other work so the cost of the factory service can go way up.According to what Dr. A told me, the DAD is no longer available.
I need one badly. The other option is the expensive DBRIII. Very good tool though.