T1N 158" Body Kit- Ft Lauderdale, FL

[Lojack72]

I know these were pretty pricey new (and likely discontinued), but I'm the third owner and they're a bit banged up so I've opted to remove rather than repair. 5-piece fiberglass set off an executive limo conversion done by Midwest on my '02, with photos on & off my Sprinter:





To make these look good again, you'll need to strip the paint & do some fiberglass repair before repainting. Nothing any decent DIY couldn't handle, but I have too many projects and too little time. There's running boards on both sides, I'm keeping the step supports that have been welded to the frame (3 total) but they'd be easy enough to duplicate using square tubing. The front bumper cover bolts on using the stock mounts, the sides are mounted using self-tapping screws. Spraying these with bedliner may be an option, was my original plan but I had to take off a couple sections to pull a dent and decided to remove them all.

Pickup only of course, as for pricing I could use some original parts (rear fender flares, driver/passenger seats, etc.) or even just a few six packs of good beer. Just hate to scrap them, and I have no room to store them long term. Send me a PM if interested, I'm on every few days & work out of my house so very flexible on pickup.